Way to simply replace few tiles of water to ground?

[Bonaccorso]

I'm trying to repalce a few tiles of water and void in New Haven (screenshot included); so far I didn't manage to successfuly launch any editor so I tried Pandora's Box. Problem is, when I put a new tile on water, it seems it still remains water - as it's still impassible. Any way to fix it or do otherwise without editors?

 

[Falkor]

The command "tile" is your friend here.
[tile static 1276

Target the top left and bottom right of the room. Then do [area inc z 1 for the same tiles. That's the trick - your added floor tiles need to be raised one to stay above the ground when you leave the area and return.



You can use different tiles or do a fancier floor than I did but the concept is the same.

 

[Bonaccorso]

The command "tile" is your friend here.
[tile static 1276

Target the top left and bottom right of the room. Then do [area inc z 1 for the same tiles. That's the trick - your added floor tiles need to be raised one to stay above the ground when you leave the area and return.

Thank you so much! Experimenting now.
And what if I won't do [area inc z 1 ?

 

[Falkor]

If you don't raise those tiles by 1, the ones over the water can disappear (or fall below the ground) when you leave the area and return.

 

[Bonaccorso]

If you don't raise those tiles by 1, the ones over the water can disappear (or fall below the ground) when you leave the area and return.

Thanks! Works just as you said