z axis and xmlspawner

[Kahn]

I built a platform high off the ground z=90 but when I spawn something it goes to ground level at times. Below it to try to stop it I placed an extra floor and a column, but still it spawns on the ground at times.
Is there any way to prevent this so that it spawns on the 90 z axis 100% of the time?

 

[Milva]

I have found in the past if I used (in pandora) the Platform ID# 1981 It would stop the spawn from under- the home range for the mobile to spawn would need to be so it does spawn on the platform- or just use this for the whole floor. Try this out - I haven't done this in quite some time

 

[Grayhawk]

You can add /z/90 to the spawner entries.

 

[Kahn]

I have found in the past if I used (in pandora) the Platform ID# 1981 It would stop the spawn from under- the home range for the mobile to spawn would need to be so it does spawn on the platform- or just use this for the whole floor. Try this out - I haven't done this in quite some time

This did not work....even tried 2 under. Thanks though
[doublepost=1517689445][/doublepost]

You can add /z/90 to the spawner entries.

Where do you add z/90 I see no entry for it

[doublepost=1517689812][/doublepost]

This did not work....even tried 2 under. Thanks though
[doublepost=1517689445][/doublepost]
Where do you add z/90 I see no entry for it

OK....while looking at my own spawner picture here I noticed the spawn range at 1....changed it to 0 and all is well...thanks guys

 

[Grayhawk]

This would be the right place: